Exchange knowledge with designers all over the world!
Hi,
need help,
I have downloaded CADint software from web and we have valid license file.The issue is we can't able to generate Bill of material.The icon is in disabled state.So please let me know,Are we missing any command.
Thanks
Prashant
Hi!
I have an application where I will be using the same sub circuit a lot. If I make changes to the sub circuit, I want the changes take place on all the occurencies of the schematics. But in the main schematic I'd like to treat the sub circuit as a component.
I think I can define a new component that consits of the sub circuit. But I haven't quite figured out how to do this.
Anyone who care to give me som hints?
Best Regards
Bernt
I wonder if there's any simple way to write a net name or a signal name and to show that it is an inverted signal. How do I get the line above the name, which indicate the inversion? In some other schematic programs you can use a backslash (\) but that don't seem to work here...
SW:
1) Fonter kan ej väljas man måste skriva in själv via dialogruta.
2) Om man sparar sitt mall som ex: "board.alarm" så kommer mallen inte upp förräns hela "board" skrivs med STORA bokstäver.
3) Vid skapande av komponent så måste man gå in/gå ur editor för att det skall sparas och uppderas. (Lesson 6)
DOC:
1) Det har försvunnit ord i Tutorial-texten ibland.
2) Det är felaktiga bilder ibland i Tutorial.
3) Tydligare namni hänvisningarna skulle inte skada.
I övrigt en någonlunda smidigt arbetssätt, detta är 4:e miljön jag jobbar i, EEDESIGNER/EDWIN/CADSTAR